Retaning Cap120837 HT2000 Max 200 Consumables Professional

Retaning Cap120837 Plasma Consumables For Max200 / HT2000 Machine

             We are a professional manufacturer of plasma cutter consumables, Our company is located in the Shanghai City, China ,it was established in 2007,but we had 10 years manufacturing experience in this field, the new factory covers an area of more than 10000 square meters .There are 50-100 workers and 20 research engineers.

            We can offer you all plasma consumables for , Kjellberg, Esab, Koike, Komatsu, Thermadyne, such as: electrode, nozzle, shield, swirl ring, inner cap, retaining cap, water tube, torch body and so on.

Technical Support:

4, Note purchase plasma cutting machine

In considering the purchase of CNC plasma cutting machine needs the following factors:

4.1 cutting thickness.

The first factor to be determined is usually to cut metal thickness. Most of the plasma cutting machine is the cutting ability and the size of current quota. Therefore, if you are cutting are | examination | large | thin metal, you should consider the low current plasma cutting machine. And despite the small machines are cutting specific thickness of metal, but may cutting quality can not be guaranteed, instead, you may also get almost no cutting wear results, the residue will be useless metal residue. Each machine will have a set of the best cutting thickness range -- to ensure that the set is suitable for your requirements. In general, plasma cutting machine selection must be based on the best cutting thickness in the limit 60%, this is the equipment in normal cutting thickness (guarantee cutting effect). Of course, the thinner the cutting effect and the faster, more thick if the cutting effect and the cutting speed is decreased.

4.2. The load rate of equipment

If you are a long time to be cut or cut automatically, make sure to check the machine work load sustained rate. Continuous load rate is simply the equipment to work overheating before cooling the continuous working time. The work load sustained rate is usually in 10 minutes as a standard to determine the percentage of. For example. 60% current 100 ampere work load cycle is that you can in the current output of 100 amps continuous cutting 6 minutes (10 minutes by 100%). The work load | test | large | cycle is high, you can continue cutting the longer.

5, The high frequency interference plasma cutting power supply

Most of the plasma cutting machine will have a guide arc, using high frequency to guide the current through the air. However, the high frequency will interfere with nearby electronic equipment, including computer. Therefore, starting method can eliminate these high-frequency potential problems may be quite beneficial.