Plasma Cutting Accessories Retaining Cap 220398 For HPR130 Machine

Plasma Cutting Accessories Retaining Cap 220398 For HPR130 Machine
 
plasma Cutting machine HPR130, HPR260, plasma consumables. plasma HPR260 plasma cutting accessories,  HPR130 plasma torch parts, hyperherm plasma cutter nozzle 220182, plasma cutting nozzle 220188, hyperherm electrode 220181, plasma cutter tips 220187, hyperherm shield 220183, hyperherm cutting shield 220189, hyperherm swirl ring 2200179, Plasma cutter swirl ring 220553. plasma cutter water tube 220340. plasma inner cap 220176, plasma retaining cap 220173, plasma cutter parts 220552.
 
FAQ:
 
Q1:Can I get a free samples to check the quality?
 
A:Sure,we can supply the free samples but you need bear the express cost by yourself.
 
Q2:Will I afford the carrier charge?
 
A:Yes,you will afford the express charge or your account is OK.
 
Q3:Can I add my trademark on my products?
 
A:Yes,we need your certificate of authorization.

 
 
 
Technical Support:
The maintenance of the plasma torch
 
1. to correctly install the torch
 
Correctly and carefully install the torch, and to ensure that all the parts fit together well, and ensures the cutting gas and shielding gas flow, before the installation will be all the components on a clean cloth, avoid dirt adhesion to components. In the "O" type ring with a little lubricant, "O" - shaped ring is appropriate, should not be more.
 
2. the wearing parts should be replaced in time before the complete damage.
 
Vulnerable parts are not used completely damaged after the replacement of, because of serious damage to the electrode, the nozzle and the eddy current ring will can not control the plasma arc, cutting torch damage easily. So for the first time found that the quality of cutting down, it should be timely inspection and replacement of wearing parts.
 
3. The connecting thread cleaning torch
 
In the replacement of wearing parts or daily maintenance inspection, must ensure that the torch of internal and external thread cleaning. If necessary, apply more than 98% of industrial alcohol cleaning or repair connection thread.
 
4 the contact surface of the cleaning electrode and the nozzle
 
Must ensure that the nozzle and electrode contact surface clean and free of oil, if the contact surface with dirt, the torch will not be able to normal working, should use such as hydrogen peroxide cleaning agent cleaning.
 
5 check cutting gas and protective gas
 
Check the flow and pressure of cutting gas and protecting gas every day, if the flow is not sufficient or leakage, should immediately stop the trouble.
 
6 avoid torch collision damage
 
In order to avoid cutting collision damage, should be properly programmed, the cutting speed limit to avoid walking. Install anti-collision device can effectively avoid the collision damage the cutting torch.
 
7. The damage reason of the most common torch
 
(1) the torch collision
 
(2) the destructive plasma arc due to the damage of the damaged parts
 
(3) plasma arc damage caused by the dirt
 
8. matters needing attention
 
(1) do not grease the cutting torch
 
(2) don't over use the "O - ring" lubricant.
 
(3) the protective cover is installed in the torch on the splash do not spray chemicals.
 
(4) do not take manual torch when use hammer.